Despre Contact |

Multi-lane speed radar is developed to monitor multiple lanes and multiple targets on the road. It is always preferred to install the radar at a distance of 15-60 meters from the vehicle detection point on gantry or L-shape pole to cover up to 4 lanes of vehicles at the same time. It can send a trigger signal to the camera at detection point and record the vehicle speed and the vehicle driving lane. The speed detection meets the international requirements for enforcement.

24GHz ISM Band internationally accepted by traffic speed enforcement
Continuously track the vehicle and identify the location and speed
Flexible installation like gantry and roadside above the traffic
Wireless connection and visual interface for configuration
Vehicle capture position within± 0.5m difference, the consistency is 99% above
All weather resistance, not affected by light, praf, ploaie, zăpadă, haze and other harsh environment

No output when powered on
1) Check if the power connection and voltage are normal, and check if the speed display screen is lit up
2) Check if the positive and negative polarities of the power supply are correct
3) Check if the communication cable is connected properly and if the wire sequence is correct
4) Check if the receiving program is running properly and if the accompanying debugging software can receive it properly
5) Check if the serial port settings of the program are correct
Receive garbled code
1) Check if the communication cable is connected properly and if the wire sequence is correct
2) Check if the serial port baud rate setting is normal
3) Check if the communication cable is severely interfered with
Do not capture
1) Check the installation angle of the radar and whether it is aligned with the lane to be inspected
2) Check if the installation angle of the radar is within a reasonable range
3) Observe whether the vehicle matches the actual situation through the vehicle simulation interface
4) Check if the capture line is within a reasonable range
5) Check if the radar sensitivity is set too low
Empty photography
1) Check if there is strong electromagnetic interference around
2) Check if the installation angle of the radar is reasonable
3) Check if the radar sensitivity setting is too high
Missing photos
1) Check the installation angle of the radar and whether it is aligned with the detection lane that needs to be covered
2) Observe whether the vehicle is driving in the tracking area through the vehicle simulation interface
3) Check if the capture line is within a reasonable range
4) Check if the radar sensitivity is set too low

Lasă un răspuns

Lasă un mesaj